'3D Studio MAX'

.
'The Making Of Porsche '
by Karabo Legwaila


Extrude the edges as shown to create the underside of the trunk lid.



Make the extrusions shown and then weld vertices in the blue circles to close of the area.


On the top side of the geometry, close off the hole as shown by making two sets of extrusions as indicated in the picture. Weld vertices in the circles.





Lighting_La_Salle



Back on the underside of the geometry, select the four edges shown in green and chamfer them by a fairly large amount so that the corners are not too sharp. I used a value of 2 but you can experiment.


Modelling the Car


Making the Accessories

Page 19

Making the Interior


Modelling the Wheels



3D Total Homepage