Extrude the edges as shown to create the underside of the trunk lid.
Make the extrusions shown and then weld vertices in the blue circles to close of the area.
On the top side of the geometry, close off the hole as shown by making two sets of extrusions as indicated in the picture. Weld vertices in the circles.
3DTotal
Advertisement - We need your support!
As
well as you tutorial hungry people eating through a terabit of bandwidth each
month we also have many additional staff and running costs involved in creating
these free pages. We want to continue bringing you many free tutorials and resources
everyday, so PLEASE check out our products and amazon affiliate schemes via the
above banners. Many thanks!
Back on the underside of the geometry, select the four edges shown in green and chamfer them by a fairly large amount so that the corners are not too sharp. I used a value of 2 but you can experiment.
