'3D Studio MAX'

'The Making Of Porsche '
by Karabo Legwaila

There is some rubber around the front of the handle connected to the hood. This is easily made by making a box and extruding it around as shown. Put symmetry and meshsmooth modifiers on it.

Let's put the grill on the trunk. To do this, we need to flesh out the trunk geometry. From the underside of the trunk cover, make four extrusions as shown.


Select the middle loop of edges and pull it down a little to create a bump as shown.

Modelling the Car

Making the Accessories

Page 18

Making the Interior

Modelling the Wheels

3D Total Homepage