'3D Studio MAX'

'The Making Of Porsche '
by Karabo Legwaila

Now extrude the selected poly a few times to greate the shape shown in the picture.

Adjust vertices in the green squares on both sides to get the shape shown.

Now all you have to do is to chamfer the edges necessary to make the edges sharp when smoothed as shown. I'll leave it up to you to figure out how.

Now just finish extruding the belt onto the clip as shown. Add a symmetry modifier to automatically create the one on the other side.


Putting everything we have done so far, the hood area should look like the picture. You probably haven't built a tire yet but the picture shows how the spare tire will be located in the hood area.

Modelling the Car

Page 18

Making the Accessories

Making the Interior

Modelling the Wheels

3D Total Homepage