3DTotal Tutorials

	Select the drilled portion.
	Lasso select the uneeded portion, yes including the front hood section and the airdam portion, we will smooth shift them in a different direction.

Press Symmetry and smooth shift the selected drilled portion and move inwards a few millimeter just about the right depth.

Now select just the airdam portion, smooth shift and move inwards.

select just hood lid portion, smooth shift and move inwards to z axis.

Select all faces and assign the default material check smoothing, on threshold input 30% and mark double sided. The car looks more detailed now!

We do not want to drill the rear portion and the front section at the same time so select these faces and hide them for a while.

At the back profile make polys out of its reference.
Create this in a blank layer not in an occupied layer.

Select the car layer and partially select the stencil layer, now perform drill operation and project it in the z axis.

Select the signal light section first then smooth shift,move backwards and assign material put a yellow color tone.
Select the trunk gap portion and smooth shift plus move backwards.

In a blank layer create this stencil.