Now
extend it, press t for the move option then press n for numeric value.
In
x value type -300mm to move the extended points inward.
Points
still selected, extend again and press i and on the x value press 0 to move the
points at the middle of the x axis.
Deselect
all and press ctrl+v for the mirror tool, press n and make sure all axis contains
0 value and check merged points.
The
next episode we will put the car's windows and details like door, hood and trunk
gaps so stay tune and model the INFINITE way!
Chapter 3
On
this chapter you will learn how to put details the infinite way.
Switch
to polygon mode.
Select
lasso this portion of the car and press - to hide them,we wanted to concentrate
at the back of the car from which we will start to put details.
A
clear vision on the rear part!
Now
select the two faces just beneath the brake lights.
Select
bandsaw and press n for the panel to appear, reset action and put the value of
30%.
Switch
to point mode and move the portion that was affected by the previous cutting.
Switch
again to poly mode and select the two faces from the same position of the plate
holder.
Now
go to next step.
On
your modelers bottom right portion switch to subpatch weight mode and select the
weight tool.Marked blue are the points to put weights on, give them about 50%
each to get a sharper corners.
