Nope
this is not a piggy bank! eliminate those holes, weld these 2 points remember
to select them in order jst like the image on the left.
Rearrange
the fenders section, make sure your project looks just like mine..
Back
in polygon mode, select two faces from the fenders lip section and bandsaw them.
Select bandsaw and press n, reset action and put 90% to its value and execute.
Now
we have a crease there!
Roller
coaster?
Two
commands, select and extend, by looking at different views frequently, your extended
polygons should stay in its right track.
Select
these 3 points and create polygon, press p.
Some
modelers think that in order to achive a sharper section they must add a series
of division.
WRONG!!!
Surgeon
General says Lightwave posses weight reduction not liposuction!
Press
W button at the lower right of modeler, hold none bar and select Subpatch Weight.On
the map Tab select Weights and start spraying on two points untill you get the
right sharpness.
Again
select these points and press p to create a four point polygon.
