After
moving points, use knife tool and cut it just like the degree of angle of our
car plate section this will prepare us from beveling it right when we go to this
step later.
Select
these points and stretch it sideways holding ctrl key while dragging, drag it
from the red arrow mark.
From
this portion i will temporary shut my mouth and you do the rest, there are 3 commands
you will use extend, move and drag.
If
you got lost, call MAMA!!!
mmmmmm........
mmmmmm........
mmmmmm........
HAH!!
Lets
talk again, select these 2 points following the order and weld them.
Select
these two points and extend.
Move
them like these...oh! try to look above if its conforming to our top reference.
