Sometimes the curve that is created from our circular fillet does not reach the end of our surface making it impossible to trim, but this can be fixed by selecting the curve left by the circular fillet and moving the CV’s to the end of the surface till the CV’s snap this will guarantee we have a legal surface to trim. Make sure to turn off surfaces so it will be easier to select the curves.
13.Trim:
Now proceed to trim the bumper
14.Trim:
Trim the lofted surface
15.Trim Results:
That second part was so much faster than the first trim. What we did at this point is more about how to layout the curve so we can get results we want.
16. Fog Light Curves:
Create two circle scales and reposition them as shown.
