Select
4 points and create poly, press f to flip if your poly is facing the opposite
direction.
As
usual.....
A
little detail...
From
the side view cut the section just like the image on the left.
In
polygon mode, select these 3 faces, Smooth shift+f.
Still
selected and from the front view rotate it as the top to be the pivot.
We
will kill the upper loop of the smooth shifted poly's and leave the lower portion
to produce an inset like.In Point mode weld this points one at a time following
the orders.
Heres
the result...
3DTotal
Advertisement - We need your support!
Move
the selected points to the red mark following the doors contour.
