3DTotal Tutorials

Looking at the image at the left select the two points and extend them.

Position them just like the sample image on the left .When your done proceed to the next step.

Weld the points from the extended fender underneath to the bumper.

Back in the front profile deselect all selected points and select four points underneath the bumper. Hit extender.

Move them a little bit backwards.

Deselect all points and select the four points in order just like the image on the left. and press p for polygon creation mode.
Now we have defined the underneath portion of the car's bumper.
Go to polygon mode and select two faces underneath from where we have created our new row of polygons, perform bandsaw.

	I prefer using bandsaw pro because of its simplicity anyway you can use the old bandsaw and produce the same result.
	Leave the value to 50% and proceed to the next step.

3DTotal Advertisement - We need your support!

The result of bansaw !
Your project should look just like the image on the left.