To
finish the eyelids, twice extrude the
edge of eye and adjust to make an edge
rounded towards the interior.
Add an edge on the higher eyelid to
detail and exaggerate it more.
Eyelids
in subdivision 2.
Extrusion
of the nape of the neck.
Extrude
before neck.
Fill
the hole with Create Face.
To
mark the jaw, first Cut and a second
for the junction with the neck.
Select
the two marked of a point and then weld
the vertices.
Cut
under the chin and Weld Target to put
in quadrangle this zone.
Make
visible the edge as shown and hide if
you need to form quads in this section
To
finish Cut on the temple and here is
the finished grid.
See
below for the subdivided iteration 2
version in
Ok
the text that went here (The whole tutorial
was originally in french) is too hard
to translate. I think it means dont
collapse the stack quite yet cos the
low poly mesh is still important for
later on ;) - Tom
