Make
these edges invisible and make Planar
the polygon thus obtained.
Extrusion
of the sleeve of the glove with Bevel
to change the size.
This
stage it is necessary to place the
glove on the body of Joan for the
adjustments.
Set
the appropriate scale to match the
body
see
above, only the Instance copy of the
glove is positioned, the original remains
in place because this position is more
practical as this time to continue modeling.
Adjust
to make more regular if necessary and
then extrude the edge to form this lip.
Lastly,
Extrude back the interior of the sleeve.
Aspect
of the glove on the positioned copy.
For
the folds in the wrist section, select
the horizontal edges and Chamfer to
duplicate them.
It
is then enough to adjust the vertexes
on cage LPM and to see the result on
the subdivided version.
Select
the edges as opposite.
Apply
Chamfer to duplicate them.
For
the dimensions of the faces, adjusted
the vertexes thus created.
Select
the faces in red.
Make
Extrude/Bevel and repeat the operation
a second time as shown.
