We
need to get rid of that triangle because
of bad subdivision. Use cut for creating
line that correspond with fold line
and make doted line edge invisible (right
picture)
Extrusion
was quite fast but the buttocks are
not round enough yet .
Two
series of Cut Edges allow to round all
that.
Position
the vertical edges regularly around
the back and side part of the thigh
and the hips.
To
mark the fold gluteus, add the marked
edges and turn them visible (the dotted
edges). Make invisible the others to
have the same aspect as on the image
on right side.
Aspect
of the grid of the buttocks seen from
back and left.
3DTotal
Advertisement - We need your support!
The
subdivided mesh, iteration 2 in Meshsmooth.
Extrusions
for the top of the bust.
Two
extrusions for the start of the neck.
While
preparing for modeling of arm, simplify
the for faces into one polygons (Weld
Target).
Insert
the edges (see picture on left) for
a better round-off of the arm.
